拓辉新材料甘油 · 英文 MSDS
Safety Data Sheet
SECTION 1: Identification of the substance/mixture and of the company/undertaking
>Product identifier
- Product name: Glycerol
- CBnumber: CB5339206
- CAS: 56-81-5
- EINECS Number: 200-289-5
- Synonyms: Glycerin,glycerol
>Relevant identified uses of the substance or mixture and uses advised against
- Relevant identified uses: For R&D use only. Not for medicinal, household or other use.
- Uses advised against: none
>Company Identification
- Company: Linyi Tuohui New Materials Co., Ltd.
- Address: Room A6159, 6F, Building 1, Linyi Software Park, No.6 Yihe Road, Zhimadun Subdistrict, Yishui New Area, Linyi City, Shandong Province, China
- Telephone: +86 176 6460 5089 (Manager Niu) / +86 130 4664 1786 (Manager Li)
- Email: nathan@tuohui-chem.com
- WhatsApp: +86 176 6460 5089
- Emergency telephone: +86 176 6460 5089
SECTION 2: Hazards identification
>GHS Label elements, including precautionary statements
- Symbol(GHS)
- Signal wordDanger
Precautionary statements
Hazard statements
SECTION 3: Composition/information on ingredients
>Substance
- Product name: Glycerol
- Synonyms: Glycerin,glycerol
- CAS: 56-81-5
- EC number: 200-289-5
- MF: C3H8O3
- MW: 92.09
SECTION 4: First aid measures
>Description of first aid measures
If inhaled
In case of skin contact
In case of eye contact
If swallowed
>Most important symptoms and effects, both acute and delayed
>Indication of any immediate medical attention and special treatment needed
SECTION 5: Firefighting measures
>Extinguishing media
Suitable extinguishing media
Unsuitable extinguishing media
>Special hazards arising from the substance or mixture
Carbon oxides Combustible.
Vapors are heavier than air and may spread along floors. Forms explosive mixtures with air on intense heating.
Development of hazardous combustion gases or vapours possible in the event of fire.
>Advice for firefighters
In the event of fire, wear self-contained breathing apparatus.
>Further information
Prevent fire extinguishing water from contaminating surface water or the ground water system.
>NFPA 704
SECTION 6: Accidental release measures
>Personal precautions, protective equipment and emergency procedures
For personal protection see section 8.
>Environmental precautions
Do not let product enter drains.
>Methods and materials for containment and cleaning up
Cover drains. Collect, bind, and pump off spills. Observe possible material restrictions (see sections 7 and 10). Take up with liquid-absorbent material (e.g. Chemizorb ). Dispose of properly. Clean up affected area.
>Reference to other sections
For disposal see section 13.
SECTION 7: Handling and storage
>Precautions for safe handling
For precautions see section 2.2.
>Conditions for safe storage, including any incompatibilities
> Storage conditions
Tightly closed. hygroscopic
>Specific end use(s)
Apart from the uses mentioned in section 1.2 no other specific uses are stipulated
SECTION 8: Exposure controls/personal protection
>control parameter
Hazard composition and occupational exposure limits
>Exposure controls
Personal protective equipment
Use equipment for eye protection tested and approved under appropriate
government standards such as NIOSH (US) or EN 166(EU). Safety glasses
This recommendation applies only to the product stated in the safety data sheet, supplied by us and for the designated use. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN374 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de).
Full contact
Material: Nitrile rubber
Minimum layer thickness: 0,11 mm Break through time: 480 min
Material tested:KCL 741 Dermatril L
This recommendation applies only to the product stated in the safety data sheet, supplied by us and for the designated use. When dissolving in or mixing with other substances and under conditions deviating from those stated in EN374 please contact the supplier of CE-approved gloves (e.g. KCL GmbH, D-36124 Eichenzell, Internet: www.kcl.de).
Splash contact Material: Nitrile rubber
Minimum layer thickness: 0,11 mm Break through time: 480 min
Material tested:KCL 741 Dermatril L
Recommended Filter type: Filter A-(P2)
The entrepeneur has to ensure that maintenance, cleaning and testing of respiratory protective devices are carried out according to the instructions of the producer.
These measures have to be properly documented.
Do not let product enter drains.
SECTION 9: Physical and chemical properties
>Information on basic physicochemical properties
- Appearanceclear viscous
- Odourodorless
- Odour ThresholdNot applicable d) pH 5,5 - 8 Melting point/freezing point Initial boiling point and boiling range Melting point/range: 20 °C 182 °C at 27 hPa Flash point 199 °C at ca.1013,0 hPa - Pensky-Martens closed cup Evaporation rate No data available Flammability (solid, gas) Upper/lower flammability or explosive limits No data available Upper explosion limit: 19 %(V) at 1013 hPa Lower explosion limit: 2,7 %(V) at 1013 hPa Vapour pressure 0,26 hPa at 100 °C 5,7 hPa at 150 °C Vapour density 3,18 - (Air = 1.0) Relative density 1,25 g/mL Water solubility at 25 °C miscible Partition coefficient: n-octanol/water Autoignition temperature Decomposition temperature log Pow: -1,75 at 25 °C 370 °C No data available Viscosity Viscosity, kinematic: No data available Viscosity, dynamic: 1.412 mPa.s at 20 °C612 mPa.s at 30 °C14,8 mPa.s at 100 °C Explosive properties No data available Oxidizing properties No data available
- Melting point/freezing pointMelting point/range: 20 °C
- Initial boiling point and boiling range182 °C at 27 hPa
- Flash point199 °C at ca.1013,0 hPa - Pensky-Martens closed cup
- Evaporation rate320 °F
- Flammability (solid, gas)No data available
- Upper/lower flammability or explosive limits Upper explosion limit: 19 %(V) at 1013 hPa Lower explosion limit: 2,7 %(V) at 1013 hPa
- Vapour pressure 0,26 hPa at 100 °C 5,7 hPa at 150 °C
- Vapour density 3,18 - (Air = 1.0)
- Relative density1,25 g/mL
- Water solubilityat 25 °C miscible
- Partition coefficient: n-octanol/waterlog Pow: -1,75 at 25 °C
- Autoignition temperature370 °C
- Decomposition temperature No data available
- ViscosityViscosity, kinematic: No data available Viscosity, dynamic: 1.412 mPa.s at 20 °C612 mPa.s at 30 °C14,8 mPa.s at 100 °C
- Explosive propertiesNo data available
- Oxidizing propertiesNo data available
- λmaxλ: 260 nm Amax: 0.05
λ: 280 nm Amax: 0.04
>Other safety information
Surface tension ca.63,4 mN/m at 20 °C
Relative vapor density
3,18 - (Air = 1.0)
SECTION 10: Stability and reactivity
>Reactivity
Forms explosive mixtures with air on intense heating.
A range from approx. 15 Kelvin below the flash point is to be rated as critical.
>Chemical stability
The product is chemically stable under standard ambient conditions (room temperature) .
>Possibility of hazardous reactions
No data available
>Conditions to avoid
Strong heating.
>Incompatible materials
Strong oxidizing agents
>Hazardous decomposition products
In the event of fire: see section 5
SECTION 11: Toxicological information
>Information on toxicological effects
Acute toxicity
Remarks: (ECHA)
LD50 Dermal - Rabbit - > 10.000 mg/kg
Skin corrosion/irritation
Serious eye damage/eye irritation
Respiratory or skin sensitization
Germ cell mutagenicity
Carcinogenicity
Reproductive toxicity
Specific target organ toxicity - single exposure
Specific target organ toxicity - repeated exposure
Aspiration hazard
Toxicity
SECTION 12: Ecological information
>Toxicity
Remarks: (ECHA)
Remarks: No data available(glycerine)
>Persistence and degradability
Biodegradability aerobic - Exposure time 2 d
Result: 90 % - Readily biodegradable. Remarks: (ECHA)
>Bioaccumulative potential
No data available
>Mobility in soil
>Results of PBT and vPvB assessment
This substance/mixture contains no components considered to be either persistent,
bioaccumulative and toxic (PBT), or very persistent and very bioaccumulative (vPvB) at levels of 0.1% or higher.
>Toxics Screening Level
>Other adverse effects
No data available
SECTION 13: Disposal considerations
>Waste treatment methods
Incompatibilities
Glycerin may explode if mixed with strong oxidizing agents such as chromium trioxide, potassium chlorate, or potassium permanganate. In dilute solution, the reaction proceeds at a slower rate with several oxidation products being formed. Black discoloration of glycerin occurs in the presence of light, or on contact with zinc oxide or basic bismuth nitrate.
Incompatibilities
Incompatible with acetic anhydrides (especially in the pres ence of a catalyst), strong acids, caustics, aliphatic amines, and isocyanates. Strong oxidizers, e.g., chromium trioxide, potassium chlorate, and potassium permanganate); can cause fire and explosion hazard. Hygroscopic (i.e., absorbs moisture from the air). Decomposes when heated, produc ing corrosive gas of acrolein.
> Product
See www.retrologistik.com for processes regarding the return of chemicals and
containers, or contact us there if you have further questions.
Waste Disposal
Mixture with a more flamma ble solvent followed by incineration.
SECTION 14: Transport information
>UN number
ADR/RID: - IMDG: - IATA: -
>UN proper shipping name
>Transport hazard class(es)
>Packaging group
>Environmental hazards
ADR/RID: no IMDG Marine pollutant: no IATA: no
>Special precautions for user
> Further information
Not classified as dangerous in the meaning of transport regulations.
SECTION 15: Regulatory information
>Safety, health and environmental regulations/legislation specific for the substance or mixture
Regulations on the Safety Management of Hazardous Chemicals
Measures for Environmental Management of New Chemical Substances
SECTION 16: Other information
>Abbreviations and acronyms
- ADR: European Agreement concerning the International Carriage of Dangerous Goods by Road
- CAS: Chemical Abstracts Service
- EC50: Effective Concentration 50%
- IATA: International Air Transportation Association
- IMDG: International Maritime Dangerous Goods
- LC50: Lethal Concentration 50%
- LD50: Lethal Dose 50%
- RID: Regulation concerning the International Carriage of Dangerous Goods by Rail
- STEL: Short term exposure limit
- TWA: Time Weighted Average
>References
【1】CAMEO Chemicals, website: http://cameochemicals.noaa.gov/search/simple
【2】ChemIDplus, website: http://chem.sis.nlm.nih.gov/chemidplus/chemidlite.jsp
【3】ECHA - European Chemicals Agency, website: https://echa.europa.eu/
【4】eChemPortal - The Global Portal to Information on Chemical Substances by OECD, website: http://www.echemportal.org/echemportal/index?pageID=0&request_locale=en
【5】ERG - Emergency Response Guidebook by U.S. Department of Transportation, website: http://www.phmsa.dot.gov/hazmat/library/erg
【6】Germany GESTIS-database on hazard substance, website: http://www.dguv.de/ifa/gestis/gestis-stoffdatenbank/index-2.jsp
【7】HSDB - Hazardous Substances Data Bank, website: https://toxnet.nlm.nih.gov/newtoxnet/hsdb.htm
【8】IARC - International Agency for Research on Cancer, website: http://www.iarc.fr/
【9】IPCS - The International Chemical Safety Cards (ICSC), website: http://www.ilo.org/dyn/icsc/showcard.home
【10】Sigma-Aldrich, website: https://www.sigmaaldrich.com/
本页为本站内置的 SDS 本地副本，可在线浏览；如需 PDF 文档，请点击右上角“下载 PDF”按钮。