四甲苯(碳十) · 英文 MSDS
Safety Data Sheet
SECTION 1: Identification of the substance/mixture and of the company/undertaking
>Product identifier
- Product name: 1,2,4,5-Tetramethylbenzene
- CBnumber: CB8262899
- CAS: 95-93-2
- EINECS Number: 202-465-7
- Synonyms: 1,2,4,5-tetramethylbenzene,Durene
>Relevant identified uses of the substance or mixture and uses advised against
- Relevant identified uses: For R&D use only. Not for medicinal, household or other use.
- Uses advised against: none
>Company Identification
- Company: Linyi Tuohui New Materials Co., Ltd.
- Address: Room A6159, 6F, Building 1, Linyi Software Park, No.6 Yihe Road, Zhimadun Subdistrict, Yishui New Area, Linyi City, Shandong Province, China
- Telephone: +86 176 6460 5089 (Manager Niu) / +86 130 4664 1786 (Manager Li)
- Email: nathan@tuohui-chem.com
- WhatsApp: +86 176 6460 5089
- Emergency telephone: +86 176 6460 5089
SECTION 2: Hazards identification
>GHS Label elements, including precautionary statements
- Symbol(GHS)
- Signal wordDanger
Precautionary statements
Hazard statements
SECTION 3: Composition/information on ingredients
>Substance
- Product name: 1,2,4,5-Tetramethylbenzene
- Synonyms: 1,2,4,5-tetramethylbenzene,Durene
- CAS: 95-93-2
- EC number: 202-465-7
- MF: C10H14
- MW: 134.22
SECTION 4: First aid measures
>Description of first aid measures
General advice
If inhaled
In case of skin contact
In case of eye contact
If swallowed
>Most important symptoms and effects, both acute and delayed
>Indication of any immediate medical attention and special treatment needed
SECTION 5: Firefighting measures
>Extinguishing media
Suitable extinguishing media
>Special hazards arising from the substance or mixture
Carbon oxides
>Advice for firefighters
Wear self-contained breathing apparatus for firefighting if necessary.
>Further information
Use water spray to cool unopened containers.
>NFPA 704
SECTION 6: Accidental release measures
>Personal precautions, protective equipment and emergency procedures
Avoid dust formation. Avoid breathing vapors, mist or gas. Ensure adequate ventilation. Remove all sources of ignition. Evacuate personnel to safe areas.
For personal protection see section 8.
>Environmental precautions
Prevent further leakage or spillage if safe to do so. Do not let product enter drains. Discharge into the environment must be avoided.
>Methods and materials for containment and cleaning up
Sweep up and shovel. Contain spillage, and then collect with an electrically protected vacuum cleaner or by wet-brushing and place in container for disposal according to local regulations (see section 13). Keep in suitable, closed containers for disposal. Contain spillage, pick up with an electrically protected vacuum cleaner or by wet-brushing and transfer to a container for disposal according to local regulations (see section 13).
>Reference to other sections
For disposal see section 13.
SECTION 7: Handling and storage
>Precautions for safe handling
Avoid formation of dust and aerosols.
Provide appropriate exhaust ventilation at places where dust is formed.Keep away from sources of ignition - No smoking.Take measures to prevent the build up of electrostatic charge.
For precautions see section 2.2.
>Conditions for safe storage, including any incompatibilities
Store in cool place. Keep container tightly closed in a dry and well-ventilated place.
>Specific end use(s)
Apart from the uses mentioned in section 1.2 no other specific uses are stipulated
SECTION 8: Exposure controls/personal protection
>control parameter
Hazard composition and occupational exposure limits
>Exposure controls
Appropriate engineering controls
Handle in accordance with good industrial hygiene and safety practice. Wash hands before breaks and at the end of workday.
Personal protective equipment
Safety glasses with side-shields conforming to EN166 Use equipment for eye protection tested and approved under appropriate government standards such as NIOSH (US) or EN 166(EU).
Handle with gloves. Gloves must be inspected prior to use. Use proper glove removal technique (without touching glove's outer surface) to avoid skin contact with this product. Dispose of contaminated gloves after use in accordance with applicable laws and good laboratory practices. Wash and dry hands.
The selected protective gloves have to satisfy the specifications of Regulation (EU) 2016/425 and the standard EN 374 derived from it.
Full contact
Material: Nitrile rubber
Minimum layer thickness: 0,11 mm Break through time: 480 min
Material tested:Dermatril (KCL 740 / Aldrich Z677272, Size M)
Splash contact Material: Nitrile rubber
Minimum layer thickness: 0,11 mm Break through time: 480 min
Material tested:Dermatril (KCL 740 / Aldrich Z677272, Size M)
data source: KCL GmbH, D-36124 Eichenzell, phone +49 (0)6659 87300, e-mail sales@kcl.de, test method: EN374
If used in solution, or mixed with other substances, and under conditions which differ from EN 374, contact the supplier of the EC approved gloves. This recommendation is advisory only and must be evaluated by an industrial hygienist and safety officer familiar with the specific situation of anticipated use by our customers. It should not be construed as offering an approval for any specific use scenario.
Flame retardant antistatic protective clothing., The type of protective equipment must be selected according to the concentration and amount of the dangerous substance at the specific workplace.
Where risk assessment shows air-purifying respirators are appropriate use a full- face particle respirator type N100 (US) or type P3 (EN 143) respirator cartridges as a backup to engineering controls. If the respirator is the sole means of protection, use a full-face supplied air respirator. Use respirators and components tested and approved under appropriate government standards such as NIOSH (US) or CEN (EU).
Prevent further leakage or spillage if safe to do so. Do not let product enter drains. Discharge into the environment must be avoided.
SECTION 9: Physical and chemical properties
>Information on basic physicochemical properties
- Appearancecolorless crystalline
- OdourNo data available
- Odour ThresholdNo data available
- pHNo data available
- Melting point/freezing pointMelting point/range: 76 - 80 °C - lit.
- Initial boiling point and boiling range196-197 °C
- Flash point74 °C - closed cup
- Evaporation rateNo data available
- Flammability (solid, gas)The substance or mixture is a flammable solid with the category 1.
- Upper/lower flammability or explosive limitsNo data available
- Vapour pressure 160 mm Hg ( 140 °C)
- Vapour density 4.6 (vs air)
- Relative density0,838 g/mL at 25 °C
- Water solubility0,00348 g/l at 25 °C
- Partition coefficient: n-octanol/waterlog Pow: 4,17
- Autoignition temperatureNo data available
- Decomposition temperatureNo data available
- ViscosityNo data available
- Explosive propertiesNo data available
- Oxidizing propertiesNo data available
- Henry's Law Constant2.49 at 25 °C (approximate - calculated from water solubility and vapor pressure)
>Other safety information
No data available
SECTION 10: Stability and reactivity
>Reactivity
No data available
>Chemical stability
Stable under recommended storage conditions.
>Possibility of hazardous reactions
>Conditions to avoid
Heat, flames and sparks. Extremes of temperature and direct sunlight.
>Incompatible materials
Strong oxidizing agents
>Hazardous decomposition products
Hazardous decomposition products formed under fire conditions. - Carbon oxides Other decomposition products - No data available
In the event of fire: see section 5
SECTION 11: Toxicological information
>Information on toxicological effects
Acute toxicity
Skin corrosion/irritation
Serious eye damage/eye irritation Respiratory or skin sensitization Germ cell mutagenicity Carcinogenicity
Reproductive toxicity
Specific target organ toxicity - single exposure Specific target organ toxicity - repeated exposure Aspiration hazard
Additional Information
The data available to us do not suffice to permit any industrial-toxicological assessment. Further toxicological data:
Risk of absorption.
Other dangerous properties can not be excluded. Further data:
Handle in accordance with good industrial hygiene and safety practice.
Toxicity
SECTION 12: Ecological information
>Toxicity
LC50 - Leuciscus idus (Golden orfe) - 30 mg/l - 48 h Remarks: (ECOTOX Database)
LC100 - Leuciscus idus (Golden orfe) - 50 mg/l - 48 h Remarks: (ECOTOX Database)
EC50 - Daphnia magna (Water flea) - 0,47 mg/l - 48 h Remarks: (External MSDS)
>Persistence and degradability
Not readily biodegradable.
>Bioaccumulative potential
>Mobility in soil
>Results of PBT and vPvB assessment
This substance/mixture contains no components considered to be either persistent, bioaccumulative and toxic (PBT), or very persistent and very bioaccumulative (vPvB) at levels of 0.1% or higher.
>Toxics Screening Level
>Other adverse effects
Discharge into the environment must be avoided.
SECTION 13: Disposal considerations
>Waste treatment methods
> Product
Burn in a chemical incinerator equipped with an afterburner and scrubber but exert extra care in igniting as this material is highly flammable. Offer surplus and non-recyclable solutions to a licensed disposal company.
> Contaminated packaging
Dispose of as unused product.
SECTION 14: Transport information
>UN number
ADR/RID: 1325 IMDG: 1325 IATA: 1325
>UN proper shipping name
ADR/RID: FLAMMABLE SOLID, ORGANIC, N.O.S. (1,2,4,5-tetramethylbenzene) IMDG: FLAMMABLE SOLID, ORGANIC, N.O.S. (1,2,4,5-tetramethylbenzene)
IATA: Flammable solid, organic, n.o.s. (1,2,4,5-tetramethylbenzene)
>Transport hazard class(es)
ADR/RID: 4.1 IMDG: 4.1 IATA: 4.1
>Packaging group
ADR/RID: II IMDG: II IATA: II
>Environmental hazards
ADR/RID: no IMDG Marine pollutant: no IATA: no
>Special precautions for user
No data available
SECTION 15: Regulatory information
>Safety, health and environmental regulations/legislation specific for the substance or mixture
Regulations on the Safety Management of Hazardous Chemicals
Measures for Environmental Management of New Chemical Substances
SECTION 16: Other information
>Abbreviations and acronyms
- ADR: European Agreement concerning the International Carriage of Dangerous Goods by Road
- CAS: Chemical Abstracts Service
- EC50: Effective Concentration 50%
- IATA: International Air Transportation Association
- IMDG: International Maritime Dangerous Goods
- LC50: Lethal Concentration 50%
- LD50: Lethal Dose 50%
- RID: Regulation concerning the International Carriage of Dangerous Goods by Rail
- STEL: Short term exposure limit
- TWA: Time Weighted Average
>References
【1】CAMEO Chemicals, website: http://cameochemicals.noaa.gov/search/simple
【2】ChemIDplus, website: http://chem.sis.nlm.nih.gov/chemidplus/chemidlite.jsp
【3】ECHA - European Chemicals Agency, website: https://echa.europa.eu/
【4】eChemPortal - The Global Portal to Information on Chemical Substances by OECD, website: http://www.echemportal.org/echemportal/index?pageID=0&request_locale=en
【5】ERG - Emergency Response Guidebook by U.S. Department of Transportation, website: http://www.phmsa.dot.gov/hazmat/library/erg
【6】Germany GESTIS-database on hazard substance, website: http://www.dguv.de/ifa/gestis/gestis-stoffdatenbank/index-2.jsp
【7】HSDB - Hazardous Substances Data Bank, website: https://toxnet.nlm.nih.gov/newtoxnet/hsdb.htm
【8】IARC - International Agency for Research on Cancer, website: http://www.iarc.fr/
【9】IPCS - The International Chemical Safety Cards (ICSC), website: http://www.ilo.org/dyn/icsc/showcard.home
【10】Sigma-Aldrich, website: https://www.sigmaaldrich.com/
本页为本站内置的 SDS 本地副本,可在线浏览;如需 PDF 文档,请点击右上角“下载 PDF”按钮。
拓辉新材料